KonnektingSoilMoisture

Installation:

Add RunningMedian and Konnekting to your Arduino library

Uncomment line "#define KDEBUG" to activate debugging via Serial Monitor Change the following lines appropriately:

• const long knownResistor = 4700;
• define PROG_LED_PIN 8
• define PROG_BUTTON_PIN 7
• define SENSOR_PIN_1 9
• define SENSOR_PIN_2 8

Upload Arduino Code on Konnekting Device

Configuration:

Run Konnekting Suite and add bodenfeuchte Device. Set the physical address, group addresses and parameters as follows:

Allgemein/General

• Startup Delay
• Pause between measurements
• Number sample measurements used for calculating Median

Bodenfeuchte/Soil Moisture

• Send value periodically: no/yes
• Pause between periodic sending in seconds
• Send value on change: on/off/none
• Minimum change for sending value in percent
• Lower threshold in percent
• Value to send when below lower threshold: on/off/none
• Repeat send below lower threshold: repeat/only send once
• Upper threshold in percent
• Value to send when above upper threshold: on/off/none
• Repeat send above upper threshold: repeat/only send once